Community AlphaAlpha MUADMINS
TRTürkçe
Giriş yap
MuADMINS'teConfig ScannerDosyalarının zip'ini yükle: rate'ler, droplar, spotlar, limitlerAçMuADMINS'teDiscord'da buluşalımYardım iste, üzerinde çalıştığın şeyleri paylaş ve diğer sunucu sahipleriyle MU hakkında konuş.Aç

MuADMINS

Çözümler

Yaygın MU Online sunucu, client ve web sitesi sorunları için kısa düzeltmeler; her biri kaynağı ve tarihiyle. “Onaylanmış”, soruyu soran kişinin düzeltmenin işe yaradığını söylediği anlamına gelir.

62 çözüm “client not connecting” için · Temizle

  1. Oyun client'ıDiğer server filesS9

    Yomalex MuEmu (C#) with the Season 9 client: CSEmu lists the server but the client shows "You are disconnected from the server" a few seconds after start.

    1. The Season 9 client used by this project is an IGCN client: rename the project Main.dll to IGC.dll and replace it in the client. 2. Do not use 127.0.0.1 as the server address: the clie...

    ✓ Sorun kaydında onaylandıGitHub (Yomalex/MuEmu) · 2023-06-28
  2. Oyun client'ıMuEmu / Louisany

    The client says "You are disconnected from the server" although the IPs, ah.info and main.info look correct. Where should I look?

    1. Check that the basic ports are open: ConnectServer (44405) and GameServer (55901, 55919 for the CS server). 2. Open the client main.info settings again and check every value: IP, port...

    ✓ Konu sahibi tarafından onaylandıTuServerMU · 2019-04-30
  3. Oyun client'ıSeason 6

    "Connect Failed" when you start the client on the PC that runs the server (No-IP address)

    With a No-IP (dynamic DNS) name in the client, players outside can connect, but the PC that runs the server often cannot, because most home routers do not route your public address back i...

    ✓ Konu sahibi tarafından onaylandıTUServerMU · 2021-04-15
  4. AraçlarIGCN

    IGC Dashboard: how to configure the client patch (ServerInfo Dashboard section, ConnectServer config.ini, setting.json)

    1. In ServerInfo.xml set the <Dashboard Run="1" ExeName="Dashboard.exe" Path="Dashboard" IsNative="1" LauncherProxyConnectServerID="-1" MainProcessName="main" MemoryShareName="IGCDashBoar...

    Kaynağın MuADMINS tarafından yeniden yazılmış haliNot verifiedIGCN · 2024-10-29
  5. Oyun client'ıDiğer server filesS17

    Yomalex MuEmu (C#): the Season 17 client does not connect to the server. What does the client need?

    1. The client must load the MUConnector DLL that comes with the project. Compile it with Visual Studio and the C++ tools in Release mode. 2. The built DLL replaces the main.dll of the cli...

    Kaynağın MuADMINS tarafından yeniden yazılmış haliNot verifiedGitHub (Yomalex/MuEmu) · 2024-09-22
  6. Sunucu kurulumu97d+99i

    "error-L1 : CloseClient INVALID_SOCKET": after some time online the GameServer disconnects all players (97d+99i, after moving from Windows Server 2003 to Windows Server 2012 R2)

    Reinstalling Windows, all updates and compatibility modes did not help; the fix was the newer DLL for the files. 1. Download the newer DLL that the developer uploaded for these 97d+99i fi...

    ✓ Konu sahibi tarafından onaylandıDarksTeam · 2017-02-14
  7. Oyun client'ıOpenMUany

    OpenMU: I start main.exe with the ClientLauncher pointing to 127.0.0.1:44405 and nothing happens, the server never sees a connection.

    1. The original client refuses 127.0.0.1. 2. Use another loopback address instead, usually 127.127.127.127, with port 44405. 3. Set it in the ClientLauncher (or in main.exe with a hex edi...

    ✓ Sorun kaydında onaylandıGitHub (MUnique/OpenMU) · 2019-02-15
  8. Oyun client'ıMuEmu / LouisS5.2

    Main 5.2 (Louis) with MuServer Update 15: 'WriteValidation > ProtocolSend Connect [0] Read Header Fail:End of file' when the client connects

    1. The asker fixed it (with help from son1xx2 on RaGEZONE) by building both the GameServer and the main without the new protocol system. 2. In the server source set #define NEW_PROTOCOL_S...

    ✓ Sorun kaydında onaylandıGitHub (LouisEmulator/Main5.2) · 2022-11-23
  9. Sunucu kurulumuS2

    Client disconnects after choosing the server; the client log shows it connecting to someone else's IP (10.0.0.33, port 55901) with Pinkof Season 2 files

    The server files and the client still pointed to the IP of the person who packed them. 1. Put your own IP in the ConnectServer server list config. 2. Put your own IP in the JoinServer con...

    ✓ Konu sahibi tarafından onaylandıDarksTeam · 2015-02-13
  10. Sunucu kurulumuMuEmu / LouisS6

    MuEmu S6 on a VPS: the client works inside the VPS, but from home it shows the antihack logo, says it could not connect and closes.

    1. When it works on the VPS itself but not from outside, the Windows Firewall of the VPS is the usual cause. 2. On the VPS, create inbound TCP allow rules for the ConnectServer port (4440...

    ✓ Konu sahibi tarafından onaylandıTuServerMU · 2018-11-18
  11. Sunucu kurulumuOpenMUS6

    OpenMU in Docker on Windows: the client sees the server list but is disconnected when joining a server.

    1. Use the client version the server targets (1.04d English, Season 6 E3). 2. Open the ports in the Windows firewall (and allow NAT edge traversal). 3. The connect server hands out the IP...

    ✓ Sorun kaydında onaylandıGitHub (MUnique/OpenMU) · 2019-11-12
  12. Sunucu kurulumuSeason 18 Episode 2

    Client disconnects right after choosing the server (server on a VPS)

    The server list shows, so the ConnectServer port is open, but the client is dropped when it moves on to the GameServer: the GameServer port is closed somewhere. 1. Find the GameServer por...

    ✓ Konu sahibi tarafından onaylandıTUServerMU · 2023-09-16
  13. Oyun client'ıOpenMUS6

    MuOnline Clone (MuMono): 'Data path not found', or the client cannot connect to the server

    1. The client needs the Season 20 (1.20.61) client data for its assets but speaks the Season 6 protocol. 2. *Data path not found*: set DataPath in Client.Main/Constants.cs to your Data fo...

    Kaynağın MuADMINS tarafından yeniden yazılmış haliNot verifiedGitHub (bernatvadell/muonline) · 2026-01-08
  14. Araçlar

    Real MU Launcher (open source): "no connection to the server" and then it does not update the client

    1. ServerURL must be a web address, not a folder on your PC: http://YOUR_WEB_IP_OR_DNS/path_to_update_folder/. A web server is needed (on a VPS or locally on your PC). 2. In Globals.cs se...

    ✓ Konu sahibi tarafından onaylandıRaGEZONE · 2024-12-29
  15. Sunucu kurulumuOpenMU

    OpenMU: a player stays 'already connected' after a dropped connection and cannot log in again, even with the right password

    1. The old session stays registered while the TCP connection to OpenMU is still open. With the web client the WebSocket proxy keeps that connection alive, so every new login gets AccountA...

    ✓ Sorun kaydında onaylandıGitHub (MUnique/OpenMU) · 2026-10-07
  16. Sunucu kurulumuIGCNS9

    IGCN Season 9: some players are disconnected right after character select and the client log shows ResourceGuard integrity errors

    1. The client log alone can mislead: also open the server side AntiHack log of the GameServer. Here it showed [AntiHack] ... Hit Hack detected for the players who were dropped. 2. In the...

    ✓ Konu sahibi tarafından onaylandıRaGEZONE · 2026-02-04
  17. Sunucu kurulumuIGCNS9

    IGCN S9 E2 repack: IGC tools do not run and the client disconnects with 127.0.0.1 in the configs

    1. Do not use 127.0.0.1 in the server IP settings of this repack. 2. Open CMD, run ipconfig and take your IPv4 address. 3. Put that IPv4 address in every server IP setting (and in the cli...

    ✓ Konu sahibi tarafından onaylandıRaGEZONE · 2019-06-11
  18. Oyun client'ıOpenMUany

    OpenMU: which connect server port should my client use, and why do I get disconnected right after choosing a server?

    1. Use port 44405 for the original client and 44406 for the open source client (sven-n/MuMain). 2. A disconnect right after server selection means the address reported by the IP resolver...

    Kaynağın MuADMINS tarafından yeniden yazılmış haliNot verifiedGitHub (MUnique/OpenMU docs) · 2026-08-23
  19. Sunucu kurulumuMuEmu / LouisS6

    MuEmu S6 (Louis): the client reaches the server selection, but when I pick the server it disconnects. What is missing?

    1. The ConnectServer port works, but the GameServer port (55901 by default) is blocked. 2. For a local test, add an inbound firewall rule for the GameServer port (or briefly turn off Wind...

    ✓ Konu sahibi tarafından onaylandıTuServerMU · 2018-11-16
  20. Oyun client'ıMuEmu / LouisS6

    Testing a MuEmu S6 server on my home PC with the public IP set everywhere, the client says disconnected when entering. How do I fix it?

    1. For a test on the same PC or LAN, do not use the public IP: your router may not loop traffic back to itself. 2. Replace the public IP with the private IPv4 address of the server PC (se...

    ✓ Konu sahibi tarafından onaylandıTuServerMU · 2018-10-28

MUTube videoları

“client not connecting” için daha fazla video

Hâlâ takıldınız mı? MU Asistanı'na sor MuGPS'te ara

MuADMINS Community Alpha: ücretsiz, topluluk tarafından yapılıyor, aktif geliştirmede.