Community AlphaAlpha MUADMINS
PTPortuguês (Brasil)
Entrar
No MuADMINSConfig ScannerEnvie o zip dos seus arquivos: rates, drops, spots, limitesAbrirNo MuADMINSEncontre-nos no DiscordPeça ajuda, mostre o que está criando e converse sobre MU com outros donos de servidores.Abrir

MuADMINS

Soluções

Correções curtas para problemas comuns de servidor, cliente e site de MU Online, cada uma com a fonte e a data. “Confirmado” significa que quem perguntou disse que a correção funcionou.

62 soluções para “client not connecting” · Limpar

  1. Cliente do jogoOutros server filesS9

    Yomalex MuEmu (C#) with the Season 9 client: CSEmu lists the server but the client shows "You are disconnected from the server" a few seconds after start.

    1. The Season 9 client used by this project is an IGCN client: rename the project Main.dll to IGC.dll and replace it in the client. 2. Do not use 127.0.0.1 as the server address: the clie...

    ✓ Confirmado na issueGitHub (Yomalex/MuEmu) · 2023-06-28
  2. Cliente do jogoMuEmu / Louisany

    The client says "You are disconnected from the server" although the IPs, ah.info and main.info look correct. Where should I look?

    1. Check that the basic ports are open: ConnectServer (44405) and GameServer (55901, 55919 for the CS server). 2. Open the client main.info settings again and check every value: IP, port...

    ✓ Confirmado pelo autor do tópicoTuServerMU · 2019-04-30
  3. Cliente do jogoSeason 6

    "Connect Failed" when you start the client on the PC that runs the server (No-IP address)

    With a No-IP (dynamic DNS) name in the client, players outside can connect, but the PC that runs the server often cannot, because most home routers do not route your public address back i...

    ✓ Confirmado pelo autor do tópicoTUServerMU · 2021-04-15
  4. FerramentasIGCN

    IGC Dashboard: how to configure the client patch (ServerInfo Dashboard section, ConnectServer config.ini, setting.json)

    1. In ServerInfo.xml set the <Dashboard Run="1" ExeName="Dashboard.exe" Path="Dashboard" IsNative="1" LauncherProxyConnectServerID="-1" MainProcessName="main" MemoryShareName="IGCDashBoar...

    Reescrita da fonte pelo MuADMINSNot verifiedIGCN · 2024-10-29
  5. Cliente do jogoOutros server filesS17

    Yomalex MuEmu (C#): the Season 17 client does not connect to the server. What does the client need?

    1. The client must load the MUConnector DLL that comes with the project. Compile it with Visual Studio and the C++ tools in Release mode. 2. The built DLL replaces the main.dll of the cli...

    Reescrita da fonte pelo MuADMINSNot verifiedGitHub (Yomalex/MuEmu) · 2024-09-22
  6. Configuração do servidor97d+99i

    "error-L1 : CloseClient INVALID_SOCKET": after some time online the GameServer disconnects all players (97d+99i, after moving from Windows Server 2003 to Windows Server 2012 R2)

    Reinstalling Windows, all updates and compatibility modes did not help; the fix was the newer DLL for the files. 1. Download the newer DLL that the developer uploaded for these 97d+99i fi...

    ✓ Confirmado pelo autor do tópicoDarksTeam · 2017-02-14
  7. Cliente do jogoOpenMUany

    OpenMU: I start main.exe with the ClientLauncher pointing to 127.0.0.1:44405 and nothing happens, the server never sees a connection.

    1. The original client refuses 127.0.0.1. 2. Use another loopback address instead, usually 127.127.127.127, with port 44405. 3. Set it in the ClientLauncher (or in main.exe with a hex edi...

    ✓ Confirmado na issueGitHub (MUnique/OpenMU) · 2019-02-15
  8. Cliente do jogoMuEmu / LouisS5.2

    Main 5.2 (Louis) with MuServer Update 15: 'WriteValidation > ProtocolSend Connect [0] Read Header Fail:End of file' when the client connects

    1. The asker fixed it (with help from son1xx2 on RaGEZONE) by building both the GameServer and the main without the new protocol system. 2. In the server source set #define NEW_PROTOCOL_S...

    ✓ Confirmado na issueGitHub (LouisEmulator/Main5.2) · 2022-11-23
  9. Configuração do servidorS2

    Client disconnects after choosing the server; the client log shows it connecting to someone else's IP (10.0.0.33, port 55901) with Pinkof Season 2 files

    The server files and the client still pointed to the IP of the person who packed them. 1. Put your own IP in the ConnectServer server list config. 2. Put your own IP in the JoinServer con...

    ✓ Confirmado pelo autor do tópicoDarksTeam · 2015-02-13
  10. Configuração do servidorMuEmu / LouisS6

    MuEmu S6 on a VPS: the client works inside the VPS, but from home it shows the antihack logo, says it could not connect and closes.

    1. When it works on the VPS itself but not from outside, the Windows Firewall of the VPS is the usual cause. 2. On the VPS, create inbound TCP allow rules for the ConnectServer port (4440...

    ✓ Confirmado pelo autor do tópicoTuServerMU · 2018-11-18
  11. Configuração do servidorOpenMUS6

    OpenMU in Docker on Windows: the client sees the server list but is disconnected when joining a server.

    1. Use the client version the server targets (1.04d English, Season 6 E3). 2. Open the ports in the Windows firewall (and allow NAT edge traversal). 3. The connect server hands out the IP...

    ✓ Confirmado na issueGitHub (MUnique/OpenMU) · 2019-11-12
  12. Configuração do servidorSeason 18 Episode 2

    Client disconnects right after choosing the server (server on a VPS)

    The server list shows, so the ConnectServer port is open, but the client is dropped when it moves on to the GameServer: the GameServer port is closed somewhere. 1. Find the GameServer por...

    ✓ Confirmado pelo autor do tópicoTUServerMU · 2023-09-16
  13. Cliente do jogoOpenMUS6

    MuOnline Clone (MuMono): 'Data path not found', or the client cannot connect to the server

    1. The client needs the Season 20 (1.20.61) client data for its assets but speaks the Season 6 protocol. 2. *Data path not found*: set DataPath in Client.Main/Constants.cs to your Data fo...

    Reescrita da fonte pelo MuADMINSNot verifiedGitHub (bernatvadell/muonline) · 2026-01-08
  14. Ferramentas

    Real MU Launcher (open source): "no connection to the server" and then it does not update the client

    1. ServerURL must be a web address, not a folder on your PC: http://YOUR_WEB_IP_OR_DNS/path_to_update_folder/. A web server is needed (on a VPS or locally on your PC). 2. In Globals.cs se...

    ✓ Confirmado pelo autor do tópicoRaGEZONE · 2024-12-29
  15. Configuração do servidorOpenMU

    OpenMU: a player stays 'already connected' after a dropped connection and cannot log in again, even with the right password

    1. The old session stays registered while the TCP connection to OpenMU is still open. With the web client the WebSocket proxy keeps that connection alive, so every new login gets AccountA...

    ✓ Confirmado na issueGitHub (MUnique/OpenMU) · 2026-10-07
  16. Configuração do servidorIGCNS9

    IGCN Season 9: some players are disconnected right after character select and the client log shows ResourceGuard integrity errors

    1. The client log alone can mislead: also open the server side AntiHack log of the GameServer. Here it showed [AntiHack] ... Hit Hack detected for the players who were dropped. 2. In the...

    ✓ Confirmado pelo autor do tópicoRaGEZONE · 2026-02-04
  17. Configuração do servidorIGCNS9

    IGCN S9 E2 repack: IGC tools do not run and the client disconnects with 127.0.0.1 in the configs

    1. Do not use 127.0.0.1 in the server IP settings of this repack. 2. Open CMD, run ipconfig and take your IPv4 address. 3. Put that IPv4 address in every server IP setting (and in the cli...

    ✓ Confirmado pelo autor do tópicoRaGEZONE · 2019-06-11
  18. Cliente do jogoOpenMUany

    OpenMU: which connect server port should my client use, and why do I get disconnected right after choosing a server?

    1. Use port 44405 for the original client and 44406 for the open source client (sven-n/MuMain). 2. A disconnect right after server selection means the address reported by the IP resolver...

    Reescrita da fonte pelo MuADMINSNot verifiedGitHub (MUnique/OpenMU docs) · 2026-08-23
  19. Configuração do servidorMuEmu / LouisS6

    MuEmu S6 (Louis): the client reaches the server selection, but when I pick the server it disconnects. What is missing?

    1. The ConnectServer port works, but the GameServer port (55901 by default) is blocked. 2. For a local test, add an inbound firewall rule for the GameServer port (or briefly turn off Wind...

    ✓ Confirmado pelo autor do tópicoTuServerMU · 2018-11-16
  20. Cliente do jogoMuEmu / LouisS6

    Testing a MuEmu S6 server on my home PC with the public IP set everywhere, the client says disconnected when entering. How do I fix it?

    1. For a test on the same PC or LAN, do not use the public IP: your router may not loop traffic back to itself. 2. Replace the public IP with the private IPv4 address of the server PC (se...

    ✓ Confirmado pelo autor do tópicoTuServerMU · 2018-10-28

Vídeos no MUTube

Mais vídeos de “client not connecting”

Ainda com problema? Pergunte ao Assistente MU Buscar no MuGPS

MuADMINS Community Alpha: grátis, feito pela comunidade e em desenvolvimento ativo.