MuADMINS
Решения
Короткие исправления частых проблем серверов, клиентов и сайтов MU Online, каждое с источником и датой. “Подтверждено” означает, что автор вопроса сообщил, что исправление сработало.
Решений: 1 по запросу “protocolsend connect” в категории «Игровой клиент» · Сбросить
Main 5.2 (Louis) with MuServer Update 15: 'WriteValidation > ProtocolSend Connect [0] Read Header Fail:End of file' when the client connects
1. The asker fixed it (with help from son1xx2 on RaGEZONE) by building both the GameServer and the main without the new protocol system. 2. In the server source set #define NEW_PROTOCOL_S...
✓ Подтверждено в issueGitHub (LouisEmulator/Main5.2) · 2022-11-23
Совпадения по части ваших слов
В этих решениях есть часть слов из «protocolsend connect»:
Disconnect when entering my 97d+99i server after changing the main.exe settings with a Main Editor
For the 97d+99i files main.exe must not be edited. 1. Put back the original main.exe of the matching client. 2. Connect through the launcher set to your server address. 3. Log in again.
✓ Подтверждено автором темыDarksTeam · 2008-07-04Yomalex MuEmu (C#) with the Season 9 client: CSEmu lists the server but the client shows "You are disconnected from the server" a few seconds after start.
1. The Season 9 client used by this project is an IGCN client: rename the project Main.dll to IGC.dll and replace it in the client. 2. Do not use 127.0.0.1 as the server address: the clie...
✓ Подтверждено в issueGitHub (Yomalex/MuEmu) · 2023-06-28The client says "You are disconnected from the server" although the IPs, ah.info and main.info look correct. Where should I look?
1. Check that the basic ports are open: ConnectServer (44405) and GameServer (55901, 55919 for the CS server). 2. Open the client main.info settings again and check every value: IP, port...
✓ Подтверждено автором темыTuServerMU · 2019-04-30'You are disconnected from the server' when selecting the server, after the IP was changed in many config files (MuEmu files).
1. Put your IP only in ConnectServer/ServerList.dat and GameServer Data/MapServerInfo.dat. 2. Leave every other IP entry at 127.0.0.1. 3. If you use the antihack, open its port 55999. 4....
✓ Подтверждено автором темыTuServerMU · 2021-02-20"Connect Failed" when you start the client on the PC that runs the server (No-IP address)
With a No-IP (dynamic DNS) name in the client, players outside can connect, but the PC that runs the server often cannot, because most home routers do not route your public address back i...
✓ Подтверждено автором темыTUServerMU · 2021-04-15MuOnline Clone (MuMono): 'Data path not found', or the client cannot connect to the server
1. The client needs the Season 20 (1.20.61) client data for its assets but speaks the Season 6 protocol. 2. *Data path not found*: set DataPath in Client.Main/Constants.cs to your Data fo...
Yomalex MuEmu (C#): the Season 17 client does not connect to the server. What does the client need?
1. The client must load the MUConnector DLL that comes with the project. Compile it with Visual Studio and the C++ tools in Release mode. 2. The built DLL replaces the main.dll of the cli...
Louis S4 update 25: entering Elbeland always disconnects.
1. Original files do not do this, so check what you added. 2. Here an effect added to a custom item caused it. 3. Remove custom effects one by one to find the bad one.
✓ Подтверждено автором темыCreandoMU · 2021-05-18