Community AlphaAlpha MUADMINS
PTPortuguês (Brasil)
Entrar
No MuADMINSConfig ScannerEnvie o zip dos seus arquivos: rates, drops, spots, limitesAbrirNo MuADMINSEncontre-nos no DiscordPeça ajuda, mostre o que está criando e converse sobre MU com outros donos de servidores.Abrir

MuADMINS

Soluções

Correções curtas para problemas comuns de servidor, cliente e site de MU Online, cada uma com a fonte e a data. “Confirmado” significa que quem perguntou disse que a correção funcionou.

1 solução para “protocolsend connect” em Cliente do jogo · Limpar

  1. Cliente do jogoMuEmu / LouisS5.2

    Main 5.2 (Louis) with MuServer Update 15: 'WriteValidation > ProtocolSend Connect [0] Read Header Fail:End of file' when the client connects

    1. The asker fixed it (with help from son1xx2 on RaGEZONE) by building both the GameServer and the main without the new protocol system. 2. In the server source set #define NEW_PROTOCOL_S...

    ✓ Confirmado na issueGitHub (LouisEmulator/Main5.2) · 2022-11-23

Resultados com algumas das suas palavras

Estas soluções têm algumas das palavras de “protocolsend connect”:

  1. Cliente do jogo97d+99i

    Disconnect when entering my 97d+99i server after changing the main.exe settings with a Main Editor

    For the 97d+99i files main.exe must not be edited. 1. Put back the original main.exe of the matching client. 2. Connect through the launcher set to your server address. 3. Log in again.

    ✓ Confirmado pelo autor do tópicoDarksTeam · 2008-07-04
  2. Cliente do jogoOutros server filesS9

    Yomalex MuEmu (C#) with the Season 9 client: CSEmu lists the server but the client shows "You are disconnected from the server" a few seconds after start.

    1. The Season 9 client used by this project is an IGCN client: rename the project Main.dll to IGC.dll and replace it in the client. 2. Do not use 127.0.0.1 as the server address: the clie...

    ✓ Confirmado na issueGitHub (Yomalex/MuEmu) · 2023-06-28
  3. Cliente do jogoMuEmu / Louisany

    The client says "You are disconnected from the server" although the IPs, ah.info and main.info look correct. Where should I look?

    1. Check that the basic ports are open: ConnectServer (44405) and GameServer (55901, 55919 for the CS server). 2. Open the client main.info settings again and check every value: IP, port...

    ✓ Confirmado pelo autor do tópicoTuServerMU · 2019-04-30
  4. Cliente do jogoMuEmu / LouisS6

    'You are disconnected from the server' when selecting the server, after the IP was changed in many config files (MuEmu files).

    1. Put your IP only in ConnectServer/ServerList.dat and GameServer Data/MapServerInfo.dat. 2. Leave every other IP entry at 127.0.0.1. 3. If you use the antihack, open its port 55999. 4....

    ✓ Confirmado pelo autor do tópicoTuServerMU · 2021-02-20
  5. Cliente do jogoSeason 6

    "Connect Failed" when you start the client on the PC that runs the server (No-IP address)

    With a No-IP (dynamic DNS) name in the client, players outside can connect, but the PC that runs the server often cannot, because most home routers do not route your public address back i...

    ✓ Confirmado pelo autor do tópicoTUServerMU · 2021-04-15
  6. Cliente do jogoOpenMUS6

    MuOnline Clone (MuMono): 'Data path not found', or the client cannot connect to the server

    1. The client needs the Season 20 (1.20.61) client data for its assets but speaks the Season 6 protocol. 2. *Data path not found*: set DataPath in Client.Main/Constants.cs to your Data fo...

    Reescrita da fonte pelo MuADMINSNot verifiedGitHub (bernatvadell/muonline) · 2026-01-08
  7. Cliente do jogoOutros server filesS17

    Yomalex MuEmu (C#): the Season 17 client does not connect to the server. What does the client need?

    1. The client must load the MUConnector DLL that comes with the project. Compile it with Visual Studio and the C++ tools in Release mode. 2. The built DLL replaces the main.dll of the cli...

    Reescrita da fonte pelo MuADMINSNot verifiedGitHub (Yomalex/MuEmu) · 2024-09-22
  8. Cliente do jogoMuEmu / LouisSeason 4 (Louis update 25)

    Louis S4 update 25: entering Elbeland always disconnects.

    1. Original files do not do this, so check what you added. 2. Here an effect added to a custom item caused it. 3. Remove custom effects one by one to find the bad one.

    ✓ Confirmado pelo autor do tópicoCreandoMU · 2021-05-18
Ainda com problema? Pergunte ao Assistente MU Buscar no MuGPS Buscar no MUTube

MuADMINS Community Alpha: grátis, feito pela comunidade e em desenvolvimento ativo.